1, the core module from the module using the HC-06, leads interface
includes VCC, GND, TXD, RXD, aside LED status output pin, the
microcontroller can be connected via Bluetooth to determine whether
the pin state, KEY pin on the slave invalid
2, led indicate Bluetooth connection status, flashes to indicate
there is no Bluetooth connection, Steady Bluetooth port is
connected and turned on
3, bottom 3.3V LDO, the input voltage 3.6 ~ 6V, when unpaired
current of about 30mA, the pairing of about 10mA, the input voltage
must not exceed 7V!
4, the interface level is 3.3V, you can directly connect a variety
of SCM (51, AVR, PIC, ARM, MSP430, etc.), 5V microcontroller can
also be connected directly, not through without MAX232 MAX232!
5, open to 10 meters effective distance of over 10 meters are
possible, but do not make this connection to ensure the quality of
6, after the pair when using full-duplex serial port, without
having to know any Bluetooth protocol, but only supports 8 data
bits, 1 stop bit, no parity communication format, which is the most
common communication format, not support other formats .
7, establish a Bluetooth connection when not support setting the
baud rate, the name, the pairing password via AT commands,
parameter set-down to save. After Bluetooth connection is
automatically switched to transparent mode
8, small size (3.57cm * 1.52cm), chip production plant to ensure
the quality of the patch. And set transparent shrink tube, dust and
beautiful, and there is some anti-static capabilities.
9, the link from the machine, computer, Bluetooth with Bluetooth
from a host with a variety of functions, most Bluetooth phones,
PDA, PSP and other intelligent terminal pairing between slaves can
not be paired.
Tips (very important):
TXD: the sending end, generally expressed as their transmitter,
normal communication must be connected to RXD another device.
RXD: the receiving end, generally expressed as their receiving end,
the normal communication TXD must be connected to another device.
Itself when normal communication TXD RXD devices connected forever!
Collected spontaneously: RXD when normal communication to other
devices connected TXD, so if you want to receive data transmitted
by its own name suggests, it is their own to receive data
transmitted, which is directly connected to its own TXD RXD, used
to send and receive test itself is normal, is the quickest and
easiest test method, when a problem first do the test to determine
whether a product failure. Also known as the loopback test.